On products made of several panels, you can make the design continue from one panel to another, so it lines up after sewing. You set this in Canvas settings in the 3D Creator.
Matching options
Which options you see depends on the product and on the area you are designing:
Pocket matches front design: the pocket uses the front design and lines up with it. Good for hoodies with a front pocket.
Back matches front: the back uses the same design as the front.
Match left and right designs: one design continues across the left and right sides, for example on an overlapping shirt front.
How to turn matching on
Open the product in the 3D Creator.
Above the canvas, use the Clothing area menu to pick the area you want to match.
Click the gear button next to the Clothing area menu. This opens Canvas settings.
Tick the matching option you want.
If you are asked to confirm, click Yes, apply matching (pocket) or Yes, match both sides (back).
Check the result in the 3D preview. You can undo the change, or untick the option to design the panels separately again.
Good to know
If you don't see the gear button, the area you are on has no matching options. Try another area in the Clothing area menu.
While a panel is matched, it takes its design from the front. To give it its own design, untick the option.
Matching works best with a design that fills the whole panel, such as a pattern or full-bleed image.
